DC to DC Converter MPPT Solar Charge Controller Battery Charger

Product Description:

• The output voltage is stabilized, free of peaks, smoothed and filtered.
• Galvanic isolation between input and output:

• No overvoltage at the output and thus protection of the consumer if the ground line is lost.
• Clean, undisturbed mass ratios, even with long supply lines.
• Stable operating voltage on site in mobile operation, e.g. Containers, trailers, roll containers etc.
• Filtering and suppression of disturbances on the input to the output side.

• Fully automatic continuous operation: The DC-DC converter can constantly work with the battery
• Surveillance-free operation: multiple protection against overload, overheating, over voltage, short circuit, Misconduct and deep discharge of the battery through electronic regulation to complete
• Switch off by built-in safety switch.

Product parameters:

Main battery " Bord "
Lead-Acid, Gel, AGM Batteries Nominal Voltage	12V
LiFePO4 Nominal Voltage	12.8V
lithium- ion( NCM) Nominal Voltage	11.1V
Capacity (Battery Size), recommended:	45-280AH
Vehicle Starter Battery "Start II":
Vehicle Starter Battery Nominal Voltage:	12V
Min. Battery Capacity (Size), recommended:	60AH
12 V / 12 V B2B Charging operation
Input Voltage Range "Start II" ,"D+" controlled:	10.5-16V
Maximum charging power:	650W
" Bord " Max. charge current	30A
Activation Control Input "D+"	8-16V
Signal Output "OK/TR", Switch Position "TR", Cutoff Relay Bypass/max	12V/1A
Signal Output "OK/TR", Switch Position "OK"	12V/1A
Input "T T" for Battery Temperature Sensor "Board I":	YES
" Ss-" "Ss+" Inputs Sensor Cables "-" and "+" for Battery "Board I":	YES
stand-by current	24mA
Main battery overvoltage protection	15.5V
weight	1.44kg
demension	190×194×70mm
Operating temperature	-20-50ºC

Product Tags:

MPPT Solar Charge Controller

      

Solar Charge Controller Battery Charger

      

12V MPPT Solar Charge Controller

      

DC to DC Converter MPPT Solar Charge Controller Battery Charger Images